Download Manual of Jensen XA2100 Amplifier for Free or View it Online on All-Guides.com.
Craftsman Dyt 4000 Lawn Tractor Manual for Mac offers a free solution for SALOMON SNS XA MANUAL STUDYING ENGINEERING A ROADMAP TO A. Jensen Xa 1120 Manual Read/Download Model number KA822 Jensen amp need wiring instructions. Jensen I need a wiring diagram or pinout for my Jensen xa1120 amp, thanks PDF Manual. Marantz 1120, Marantz CD6004, DIY. Read and download John Deere Lawn Mowers 100 Series User's Manual online. Download free John Deere user manuals, owners manuals, instructions, warranties and installation guides, etc.
Brand: Jensen
Category: Amplifier
Type: Manual for Jensen XA2100
![Jensen xa 1120 manual lawn tractor Jensen xa 1120 manual lawn tractor](http://www.vintagegolfcartparts.com/media/ecom/prodsm/PU238.jpg)
Pages: 12
®
Troubleshooting
Amplifier does not operate
vehicle and radio are on
turned up too high for amp
Radio volume is too sensitive
Sound distorted
Alternator whine in outputs
Loud pop in speakers when
Protect light comes on/
No output on channels
No power to +12V terminal
Fuse blown
adjusted too low
Defective speaker
Speaker wires shorting together
Input level control adjusted too high
Power wires hooked up incorrectly
Radio has poor noise immunity
connected
Faulty speaker connection and/or
Low battery voltage
per channel
speakers properly
Repair wire or connections
Check fuse
Adjust input level control to lower setting
Check connections
Replace cable
Separate speaker wires and insulate
Check speakers
Disconnect audio inputs to amplifier – if noise disappears
Make sure radio and amplifier are grounded to the same point
Refer to page 4 for proper installation. If radio does not have a
power antenna lead and you have connected the remote lead to
an ignition source then you may get a “pop” in your speakers.
This is not uncommon. You may have to put a switch in line with
Let amp cool down before attempting to turn back on (some
installations may require a fan to keep the amp cool, especially if
Check speakers and/or crossovers for loose or bad connections
Make sure you are getting between 10.8-15.6 volts to the
amplifier with a digital multimeter measured at the amplifier
If you are using 4 ohm speakers you cannot have more than two
speakers wired in parallel per channel Amp will not operate
Refer to pages 5, 6 and 7 for proper installation
Contact Jensen Technical Assistance (1-800-323-0221)